[Chrome 22'S Found And Purchased]

Got the rims this week, replaced the bad tire and installed em and cleaned em up yesterday. I like em. The Boss 20" 330 are going on the VR tomorrow and a good cleaning. I will post some pics of it when done.

 

Rgds,

 

Dave

 

 

 

 

Dave,

What size tires are those?

Thanks,

Steve

[New times after stall]

Hooked up ok, spun the tires because this temple isnt the best track. Reaction time sucked at .8 here are the times guys after the stall. Before the stall best 60 ft was 2.09 and best 1/4 was 14.209

 

 

60 ft----1.8898

330ft----5.5686

1/8------8.7317

1/8mph--77.51

1/4-----13.7852

1/4mph--95.56

 

what do yall think?

Great times man. Are you getting wheelspin off the line? What stall speed did you get?

[New Best at the Strip]

I went up to Da Grove last night to see how the truck would run. I now have a smaller pulley and exhaust done to the truck since the last time I went. It wasn't the best conditions out but I went anyways. We had to wait for over an hour while they tried to dry the track. My first run up I made a 13.5 pass, but I had to let up off the line from spinning so hard. Then I ran it again hot but this time I did a quick little spin of the tires to try and dry them off and I ran a [email protected]. The truck was feeling pretty strong, but I couldn't hook up all that easy. I let the truck cool off for 45 min. and made another pass. This time the truck was still spinning off the line but ran pretty good down the track. I ran a [email protected] I wanted to make another pass but they shut it down due to rain. I can't wait to get a little better tune in the truck and some dry track so I can really hook and go!

 

Great times, are you spinning the tires at all?

[McGaughy's drop, really stiff rear ride, Help.]

Tomorrow I am going to install my McGaughys 2/3 spindle and hanger/shackle kit. I will take pics and post them. I will take step by step and before after side view. I will need help posting them though because I have just been a voyer here until now. Question; will I need to re-align with a front spindle? The upper and lower control arms should still be in the same place with the same Camber, caster, etc... The only thing that shoule change is the heigth of the spindle shaft/axle right? of course if the new cast spindles were built incorrectly an alignment would be in order.