[The Official L.E.D. How To Guide]

then i took the resistors and bent one side over and snipped almost all of it off, then took the led and cut the positive leg down to almost nothin.

then i soldered them together to make them like this

then desolder one bulb at a time and solder then new ones in.

 

sorry i forgot to take a pic of the circuit board with my positive marks so i marked the rubber and took pics. positive is the side marked with a line

make sure to keep the resistor close to the led otherwise it will hit when you puch the buttons. test the circuit board before putting it back together and make sure they all light up.

this pic shows the difference with the blue condom over the stock bulbs.

i did not put leds in the pwr button and the tune buttons just because it looks like it would have been a real big pita. so i got some transparent fabric for now until i can get some red gel film for them.

then put it all back together and enjoy.

Any chance to see these pics? I've been working on this now for a few days trying to figure out the polarity to get all of my LED's to work. I would very much appreciate it =), thanks!