ty2185

OBX header pn 501-1310-6. I need 2 Donut Style Exhaust Gasket. Anyone have a part number or dimension for replacements? I sent a messgae to OBX no reply yet. Thanks

Thanks for the Info!

Did you get the rebuild done by DTS? What did it cost? how long did it take? I'm needs a rebuild before this winter.

Do you have a part number for OE front axle asby?

any particular vendor?

Yes you would need to change your front diff gearing also.

Close please...Thanks Time2Kill

10-4

To diagnosis which one is bad. A good wheel speed sensor will typically produce an AC voltage reading of 50 to 700 mV when the wheel is turning one revolution per second. Hook a volt meter set on AC to the sensor end of the connector. Spin the tire and measure the voltage. Lower than 50mV is your bad sensor.

Thanks I'll put them on my list of things to do.

I found exhaust local to me. Thanks Guys!

Still looking for a muffler back exhaust.

The header bolts? What would you suggest?

Does anyone have a email address for rojo 143? I would like to get more infomation on the truck I just bought. It used to be Justin's. Thanks in advance. Wade

I have your old truck! I sent you a PM.

Cool thanks a video would be great.

Must be fake cats. Just pick up the truck with no information. Good to know on the stock exhaust and no drone. xr4tic where are you located in Michigan? I would like to hear your truck maybe copy your setup.

The inline tube kit is $200 for SS Lines and pre-bent,

Corsa will bolt on to OBX Catted LT headers?

The truck has OBX LT Catted headers. So I guess I need to figure out what I need to do to quite it down and get rid of the drone on the Highway.

Thanks for the welcome guys. Still working on what all the mods that it has. Looks like OBX LT catted headers. I bought it from a dealer with no information. Anyone from Detroit area familiar with this truck? I not driving too much until I know it was tuned properly.

Thanks... I think you are correct. What is a good sounding no drone Cat back to go with these?

What are you doing for the rest of your exhaust?

Anyone want to guess who makes these Catted LT Header and crossover? Here's the drivers side.

Long shot but anyone have a stock system laying around that they don't want? Near Michigan would be helpful. LMK