SSThunder Posted February 16, 2007 Report Share Posted February 16, 2007 The 3.3 is ok for now but I'm already looking to get more boost. Can my trans handle a 3.0 pulley? I have a zippy shift kit/servos and a TBTC. I don't want to get a built trans for awhile since I dropped a lot on the radix setup already. Hard to tell the wife well I think I'll spend $3K on my truck lol What's the safest pulley to run on my trans with the mods I have? Quote Link to comment Share on other sites More sharing options...
Krambo Posted February 17, 2007 Report Share Posted February 17, 2007 Rule of thumb: The life of your tranny is inversly proportional to the amount of power you make (everything else being the same). With tuning, going to the 3.0 pulley isn't going to add a "ton" of power so I say go for it! BTW, I had a STOCK tranny spinning the 2.8" pulley and a ton of other mods. She held up but it depends alot on operator Quote Link to comment Share on other sites More sharing options...
SSThunder Posted February 18, 2007 Author Report Share Posted February 18, 2007 Rule of thumb: The life of your tranny is inversly proportional to the amount of power you make (everything else being the same). With tuning, going to the 3.0 pulley isn't going to add a "ton" of power so I say go for it! BTW, I had a STOCK tranny spinning the 2.8" pulley and a ton of other mods. She held up but it depends alot on operator Sounds good. I don't run it hard. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.