HOD954 Posted April 12, 2007 Report Share Posted April 12, 2007 i was wondering if any one could tell me where would be a good place to tie in to get an accurate reading for fuel pressure?i got the gauge and im going to install this weekend.. Quote Link to comment Share on other sites More sharing options...
SSThunder Posted April 12, 2007 Report Share Posted April 12, 2007 I tied mine into the driver side fule rail. There was a spot for one on my maggie. I had to unscrew the valve and screw in the sender unit. Make sure to use the tape on the threads so it won't leak. Make sure you have the correct sender and wiring harness. Autometer included the wrong wiring harness with my gauge. This info is for a radix SC. Quote Link to comment Share on other sites More sharing options...
RevolutionRaceWorks Posted April 12, 2007 Report Share Posted April 12, 2007 If you are running the stock intake you are going to need a -4 to 1/8th npt adapter and you an remove the core from the shrader valve and install the adapter and then the fuel pressure sender on there. Quote Link to comment Share on other sites More sharing options...
HOD954 Posted April 14, 2007 Author Report Share Posted April 14, 2007 IM running the stock intake i will have to look into the install further thanks for the help Quote Link to comment Share on other sites More sharing options...
redssinpgh Posted April 18, 2007 Report Share Posted April 18, 2007 If you are running the stock intake you are going to need a -4 to 1/8th npt adapter and you an remove the core from the shrader valve and install the adapter and then the fuel pressure sender on there. I had a hell of a time figuring that out until someone told me I needed the -4 AN fitting. I also had to run a wire from the sending unit to a good ground. Good luck Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.