Black2003SS Posted June 13, 2007 Report Share Posted June 13, 2007 What DTC's do I need to disable after I remove my cats and replace with off road pipes tomorrow? I'm going to have them rig something up where I can just unbolt the offroad pipes and boltthe cats back in when necessary and I want to disable the O2 sensors after the cats so they dont throw codes afterwards. Quote Link to comment Share on other sites More sharing options...
packjh Posted June 13, 2007 Report Share Posted June 13, 2007 dont know about the dtc's but you could use exhaust clamps instead of bolts. Just clamp in clamp out Quote Link to comment Share on other sites More sharing options...
Black2003SS Posted June 13, 2007 Author Report Share Posted June 13, 2007 Going to use ball flanges with the two bolts on each or something similar to the stock flange system...with clamps, it is slip over and then you have to move the entire exhaust to get it out...you have to have flanges with bolts on at least one end. Quote Link to comment Share on other sites More sharing options...
Krambo Posted June 13, 2007 Report Share Posted June 13, 2007 See my reply in this thread: Rear O2 codes Quote Link to comment Share on other sites More sharing options...
Black2003SS Posted June 13, 2007 Author Report Share Posted June 13, 2007 Thanks Kevin...just what I was looking for. However, I'm finding that all the garbage underneath is leaking and I am leaning towards a set of OBX's now because I cant afford the dynatechs. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.