jon1178 Posted August 18, 2007 Report Share Posted August 18, 2007 well i was going to grease all my fitting on the front end now that i have my drop all finished and i made a stupid mistake. i had to replace my lower ball joint on the passenger side and i just noticed that i have the damn fitting pointing toward the spindle just enough where i cant get grease to it . has anyony else made this mistake? do they make a fitting for the grease gun with a 90* end on it or will i be pulling the damn spindle again. let my mistake be a lesson to anyone replacing ball joints. Quote Link to comment Share on other sites More sharing options...
jon1178 Posted August 18, 2007 Author Report Share Posted August 18, 2007 wait a minute i just thought of something can just take the fitting off and replce it with a fitting that is not angled? Quote Link to comment Share on other sites More sharing options...
BRAD Posted August 18, 2007 Report Share Posted August 18, 2007 I wouldnt see any reason why you couldnt just change the grease fitting. I would say go for it ;) Quote Link to comment Share on other sites More sharing options...
rivierakid55 Posted August 18, 2007 Report Share Posted August 18, 2007 ive already changed a couple fittings to 90's to make them easier to access from underneath the truck. you should defniately be able to change them out. Quote Link to comment Share on other sites More sharing options...
jon1178 Posted August 19, 2007 Author Report Share Posted August 19, 2007 cant change out the fitting on the ball joint i guess thos are not replaceable. Quote Link to comment Share on other sites More sharing options...
1BAD2K Posted August 22, 2007 Report Share Posted August 22, 2007 im pretty sure you can change the grease zerk out to whatever you need it to be. straight or 90* Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.