New 2/3 Drop Done

[ItsJac]

OKAY, before install rear was 1.5" higher than front.after install rear was .75" lower. after moving the 2 plates from the top to the bottom of the leaf, the rear is 1" higher than the front. so as of now it turned out to be about a 2/2.5 drop. if i calculate right , if you put 1 plate on the bottom and left 1 on top the truck would be almost exactly level. since i stripped out the pins that allign the individual leaves together, i might try that set up when i get new pins,just to see. but i think i need to leave it a little higher in back because i haul a motorcycle pretty regular. again fellas thanks for all the input.

I would leave the back a little higher if you haul anything. I did the belltech shocks and were happy with them. Good luck. JAc

[yttaf]

I have the belltech leafs in back & it sits right at 32 3/4" on both sides from the ground to the lip. This is with both plates still on top of the leafs.

[1BAD2K]

OKAY, before install rear was 1.5" higher than front.after install rear was .75" lower. after moving the 2 plates from the top to the bottom of the leaf, the rear is 1" higher than the front. so as of now it turned out to be about a 2/2.5 drop. if i calculate right , if you put 1 plate on the bottom and left 1 on top the truck would be almost exactly level. since i stripped out the pins that allign the individual leaves together, i might try that set up when i get new pins,just to see. but i think i need to leave it a little higher in back because i haul a motorcycle pretty regular. again fellas thanks for all the input.

cool, can we get some pics of it now?