ANGRYGREG Posted December 16, 2008 Report Posted December 16, 2008 They are finishing up my engine build, 408 stroker with maggie. My truck is a 2004 AWD SSS... I was wondering if there is some way to disconect the front drive shaft and get a RWHP reading or is that going to be a problem. If anyone has done this please help me out. My tuner can tune on the street but i just want to see what kind of power it's making. also if the front is disconnected is there a percent that i have to account for that would have been going to the front wheels..thanks... Quote
chpspecial Posted December 16, 2008 Report Posted December 16, 2008 yes it can be done, just unbolt the four 11mm bolts that hold the ds to the diff and pull it out of the tc. Just make sure you do not drive the truck on the street with the front diff disconnected. only on the dyno. Quote
ANGRYGREG Posted December 16, 2008 Author Report Posted December 16, 2008 yes it can be done, just unbolt the four 11mm bolts that hold the ds to the diff and pull it out of the tc. Just make sure you do not drive the truck on the street with the front diff disconnected. only on the dyno. Thank you for your help. Have you done this yourself. I talked to Chase and he said you have to throw it into nutral after long pulls. Any other input would be great. Thanks for your help guys.... Quote
chpspecial Posted December 16, 2008 Report Posted December 16, 2008 Thank you for your help. Have you done this yourself. I talked to Chase and he said you have to throw it into nutral after long pulls. Any other input would be great. Thanks for your help guys.... Yes both chase and I did it... the only advice is to not keep it in gear with the brakes applied, the tc will make some crazy noises. when in gear keep the rear wheels rolling, even at low speeds. when stopping, then put the trans in neutral Quote
ANGRYGREG Posted December 16, 2008 Author Report Posted December 16, 2008 Yes both chase and I did it... the only advice is to not keep it in gear with the brakes applied, the tc will make some crazy noises. when in gear keep the rear wheels rolling, even at low speeds. when stopping, then put the trans in neutral Is there any possible way to do some serious damage.. just making sure..thanks again for all your help Quote
mean05 Posted December 16, 2008 Report Posted December 16, 2008 hell i have dynoed mine quite a few times with no problem at all...have even driven it around the block also :o Quote
hellbents10 Posted December 18, 2008 Report Posted December 18, 2008 I sure would not be putting my truck in neutral after a run. Good way to explode the drum and send it and other parts out of the trans and possibly into the truck. Quote
mean05 Posted December 18, 2008 Report Posted December 18, 2008 for sure just leave it in drive and let the dyno slow you down Quote
ANGRYGREG Posted December 18, 2008 Author Report Posted December 18, 2008 for sure just leave it in drive and let the dyno slow you down thanks again guys for the help. Quote
chpspecial Posted December 29, 2008 Report Posted December 29, 2008 I meant put the truck in neutral just when or after the wheels have stopped, not anytime before... my bad Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.