SSmoothSilSS Posted June 28, 2010 Report Share Posted June 28, 2010 I have the Blackbearperformance harness, the pcm cover is off, how do you get the plastic cover off with out breaking everthing to get the pins in. The screws have a clip holding in place do you have to pull that off? And were are you hooking up you positive and negitive leads the harness leads are to short to make it to the battery or the fuse centere. Quote Link to comment Share on other sites More sharing options...
rojo_143 Posted June 28, 2010 Report Share Posted June 28, 2010 The tabs one either end with the ribs on them. You need a pair of needle nose pliars and you have to grab on to them and pull out then i used a flathead to get the rest loose. hope it helps any more questions just ask i did mine last week. Quote Link to comment Share on other sites More sharing options...
SSmoothSilSS Posted June 28, 2010 Author Report Share Posted June 28, 2010 Thanks, where did you grab negative from I see I can get the positive from the red cap box. Thanks Clay Quote Link to comment Share on other sites More sharing options...
rojo_143 Posted June 28, 2010 Report Share Posted June 28, 2010 on the frame behind the driverside brake duct there is a grounding point. here these are the instructions of the HPM fans but alot of it is the same. HPM E-fan install Quote Link to comment Share on other sites More sharing options...
SSmoothSilSS Posted June 28, 2010 Author Report Share Posted June 28, 2010 Ok got the covers off, thanks for the file, my harness is alittle different, short wires. Back to the garage Quote Link to comment Share on other sites More sharing options...
12'SROCK Posted June 28, 2010 Report Share Posted June 28, 2010 (edited) Put the ground wire on the alternator bracket (BBP wireharness) . There is a bolt already on there and you can use that one. Edited June 28, 2010 by WICKEDOWESIX (see edit history) Quote Link to comment Share on other sites More sharing options...
SSmoothSilSS Posted June 28, 2010 Author Report Share Posted June 28, 2010 Put the ground wire on the alternator bracket (BBP wireharness) . There is a bolt already on there and you can use that one. Check in, thats next, Ok thanks, man it said to use needle nose to get the pins in I use some twezzer, didn't have needle nose that small. Takes time to figure out how to get the pin covers off. Done Quote Link to comment Share on other sites More sharing options...
SSmoothSilSS Posted June 29, 2010 Author Report Share Posted June 29, 2010 Got them done works fine. Quote Link to comment Share on other sites More sharing options...
rojo_143 Posted June 29, 2010 Report Share Posted June 29, 2010 congrats you will love them!!! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.