Typical Chevy Lean

[firehawknwv]

I was wondering if there was a way to correct the "chevy lean"? I couldnt really find much on it It just sux a lil that the drivers side of the truck leans a bit lower than the left especially after lowering it. I jsut wasnt sure if its something that can be corrected or not.

[smoothdime]

thats the beauty of torsion bars. just adjust the lower side bar until you get your desired stance. if you adjust it quite a bit an alignment is recomended. good luck. gary

[firehawknwv]

I didnt know the T-bars would control the lean in the rear.

[Fireman31]

It's common, I have seen many with it including my own. I wouldn't worry about it IMO, gives the truck character.

[smoothdime]

I didnt know the T-bars would control the lean in the rear.

 

 

say you lower the left front, its going to slightly raise the right rear. but i thought you were talking about the front since most "chevy lean" is refering to the front end not the rear.

[firehawknwv]

I have a 2/3 belltech drop. My drivers rear fender is closer to the tire than the pass side by abour 1/4 to 1/2 inch. I still have to cut the bottom ring of the front bumpstops off cuz its rough riding and jsut havent gotten to it yer. Aslo plan to bring the t-bars down just a tad.