[Transmission Squealing]

Truck was tuned for a 3k stall, but the shift solenoids werent taken out of it

[Transmission Squealing]

Got my truck back from the transmission shop about a month ago with a rebuilt trans(with better internals) & a 3000 stall

 

This past week i had an issue with the shift solenoids not allowing the truck to go into overdrive and messing with the shifts. Well now when i try to drive it in 1 or 2 because drive is not working there is a loud squealing noise coming from the transmission or transfer case. I am wondering what this could be and if it would be as simple as clearing the codes from the truck and deleting out the codes on the tune.

 

Any help would be appreciated.

[Broken Dipstick Tube]

I ended up having to take the longtube off on the passanger side and get at it with a vice grips and an easy out since it was snapped off in the block. This ended up breaking it before the o-ring and the rest of the tube fell into the pan. Lots of swearing and too much work just to get a new dipstick tube. Thanks for the help guys!

[Broken Dipstick Tube]

the whole dipstick tube snapped at the block due to rust... so not that easy!

[Broken Dipstick Tube]

I have an 03 SS and i had the dipstick tube break off on me!

 

I need some advice on how to get this thing out! I used an easy out and got it free enough to spin but i cannot get the piece out from the top or bottom.

 

Thanks in advance

[WTB stock SS exhaust Tips]

I have one that i cut off behind the axle, its not polished, you could probably get it to that point though.

[WTB Stock exhaust pipes]

i have a set of down-pipes with the cats with only 20,000 miles on them before they were taken off of an 05.

[WTB: Stock catalytic converters]

I have a set

[Trailblazer SS intake manifold with fuel rails and injectors]

PM sent

[Valve body tick]

Well that just sounds shady.

From what i have read, they put in one quart of trans fluid with the other five quarts and run it hard for 100 miles and then change the oil... the detergents in the ATF help to clean out the lifters...

 

Still cautious to try this because it just doesn't seem right!

[Valve body tick]

I did try the seafoam trick, but that didnt seem to help.

 

Also i run Mobil 1 full synthetic.

 

 

I have heard of putting Trans fluid in your oil for 100 miles to try and clean out the lifters?

[Valve body tick]

It is also throwing a knock sensor... which were just replaced at 238k

[Valve body tick]

I have a 2003 Silverado SS... 249k on the clock and she is starting to get a tick in the valve body somewhere. I'm not sure whether it is lifters or not, but are there any solutions to get lifter tick to stop? Figure i should try the cheaper route before i replace anything.

 

Thanks in advance!

[My first ss in wisconsin]

ss owner from up north! Tomahawk, WI here!