mbpsychoSS Posted January 21, 2006 Report Share Posted January 21, 2006 Just got it .......compucar nos...............no instructions , have supercharged whipple any ideas Link to comment Share on other sites More sharing options...
04CHASE Posted January 21, 2006 Report Share Posted January 21, 2006 wet or dry kit? need more details on the kit( i dont feel like searching) Link to comment Share on other sites More sharing options...
mbpsychoSS Posted January 22, 2006 Author Report Share Posted January 22, 2006 http://www.compucarnitrous.com/inst.htm Been a week .............what no suggestions Link to comment Share on other sites More sharing options...
Viperkiller97 Posted January 29, 2006 Report Share Posted January 29, 2006 Street Heat Installation THIS IS A VERY SIMPLE INSTALLATION! Install the steel line into air duct (hose going to Carb or EFI Throttle Body). Attach plastic line to the steel line using compression fitting. Run plastic line back to bottle location (behind seat, truck area, etc.) Attach plastic line to braided steel line on bottle, be sure to tighten the nut for the plastic line. Remove braided line from solenoid and insert jet from jet card into fitting, Replace the braided line. (If you have just received your kit new in the box, this step has been done at the factory.) Plug powerline into ashtray lighter plug. Pull coil cord out and place in a easy location to reach. Turn on bottle! Check for leaks! The system is ready to go! (DO NOT ACTIVATE THE SYSTEM WITHOUT THE MOTOR RUNNING ) Crank car and go to your local drag strip for a ride! At wide open throttle, push the button when you want the system to run. Turn loose of button when you want the system to cut off (Simple isn't it!) Found this on that web site Is this the kit you bought. Link to comment Share on other sites More sharing options...
mbpsychoSS Posted January 29, 2006 Author Report Share Posted January 29, 2006 Yes came off a joe gibbs sc 5.7 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.