TurbochargedBerserker Posted September 16, 2006 Report Posted September 16, 2006 I finally got my trouble with the rivets sorted out (air hammer was dying and finally died... With the new one, they popped out in 2 minutes) and went to through the DS spring up... No go. The bolt that holds the bar eyelet to the caltrac dohickey hits the belltech hanger. I clearenced it (aka cut out about an inch out of the hanger) and not it will work. Trying to decide if I will do any welding now that I cut up the hanger... I will post some pics when I've got it in final form.
VHO_Tek Posted September 16, 2006 Report Posted September 16, 2006 The bolt that holds the bar eyelet to the caltrac dohickey hits the belltech hanger. <{POST_SNAPBACK}> Which dohickey? The one that has the thingamajig on it or the one on the whatsyamacallit?
TurbochargedBerserker Posted September 16, 2006 Author Report Posted September 16, 2006 The bolt that holds the bar eyelet to the caltrac dohickey hits the belltech hanger. <{POST_SNAPBACK}> Which dohickey? The one that has the thingamajig on it or the one on the whatsyamacallit? <{POST_SNAPBACK}> Well this dohickey has both a thingamjig and a whatsyamacallit ;)
04CHASE Posted September 16, 2006 Report Posted September 16, 2006 would they work with the beltech leafs and stock shackles?
Jonmalibuss Posted September 16, 2006 Report Posted September 16, 2006 As long as the bushing is the same diameter in the belltech leafs as the stock leafs then yes
Recommended Posts
Archived
This topic is now archived and is closed to further replies.