Need Help

[jm3907]

PO120-Throttlebodysensor

 

Truck idles all weird amd the check engine light and thr traction control light came on, what could have caused and whats the easiest fix

[Willoverkill]

After searching around I found on another forum where people said the wires go bad.

 

Here is a diagram of the wiring for the TB. Should be the same for your truck.

http://www.justanswer.com/view_image.aspx?href=http://gsi.xw.gm.com/image_en_us/gif/000/000/672/672842.gif

 

http://www.ls1truck.com/forums/mechanical/29020-p0120-p0220-p1516-codes-help.html

 

Hope that helps.

 

#PIP3089B: SES Light And Reduced Engine Power DTC P0120 P0220 P1516 P2135 - keywords accelerator actuator APP blade body connector connection DTC L33 L59 LH6 LR4 LM7 LS1 LS2 LQ4 LQ9 module position reduce sensor - (Oct 31, 2006)

 

 

Subject: SES Light and Reduced Engine Power DTC P0120 P0220 P1516 P2135

 

 

Models: 2004-2006 Buick Rainer

 

2005-2006 Cadillac CTS-V

 

2003-2006 Cadillac Escalade

 

2003-2006 Chevrolet Avalanche, Corvette, Express, Monte Carlo, Silverado, SSR, Suburban, Tahoe, Trailblazer

 

2003-2006 GMC Envoy, Savana, Sierra, Yukon

 

2003-2006 Hummer H2

 

2005-2006 Pontiac GTO

 

Equipped with a 4.8 5.3 6.0 or 7.0 V-8 Engine

 

The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI.

 

Condition/Concern:

A vehicle may be brought into the dealer for a reduced power message, and DTCs P0120, P0220, P1516, P2101, or P2135.

 

The Throttle Actuator Control (TAC) / throttle body type trouble codes, may be caused by a loose wiring crimp at the throttle body connector, or a broken throttle body circuit.

 

Recommendation/Instructions:

Complete the current SI diagnostics for any symptoms or trouble codes found. If a intermittent T/P or TAC module type code is occurring complete the inspections below.

 

Inspect all related throttle body terminals for a loose wiring crimp. The loose crimp may be difficult to find, and the poor connection will be between the terminal and the copper strands of the wire. Wiggle test the individual throttle body circuits to see if the concern can be duplicated.

Inspect the related circuits for broken wires inside the insulation. The outer wire insulation may look fine, but the internal copper strands may be partially broken. Breaks in the wires usually occur within 1 to 4 inches of the throttle body connector. Wiggle testing may also induce a trouble code to set.

On C/K trucks complete SI procedures for voltage drop on grounds G103 and G104. Grounds G103 or G104 may be loose or corroded.

If a terminal crimp or a broken wire has been found, repair or replace only the circuits involved. There is a throttle body pigtail connector available through GMSPO, but installing this pigtail connector may cause other intermittent TAC module/TP codes at a later date. If this pigtail must be used, please follow the SI procedures for Splicing Copper Wire Using Splice Sleeves. (the proper Kent-Moore crimping tool must be used for this repair)