The_aSSet Posted November 1, 2012 Report Posted November 1, 2012 (edited) Got home yesterday and had a little puddle under the truck, its leaking coolant very slowly from the bottom back corner of the passenger side head. I tried to tighten that bolt and it stopped dripping but apparently started back up this afternoon. Really don't wanna take the head off. Any ideas guys? I might go through the tightening sequence again just for thoroughness. and yes it was torqued with a torque wrench in sequence. Edited November 1, 2012 by The_aSSet (see edit history) Quote
canadianVRss Posted November 1, 2012 Report Posted November 1, 2012 I had the same problem with the drivers side head. Turned out that I hadn't tightened the little coolent lines from the throttle body tight enough and the coolent was traveling down the side of the head. Quote
The_aSSet Posted November 1, 2012 Author Report Posted November 1, 2012 Hmm, ill go through all the lines and bolts again Quote
canadianVRss Posted November 1, 2012 Report Posted November 1, 2012 Also, on those little lines there should be a tiny little O-ring inside where it bolts to the head. I know for sure there is on the drivers side. Not too sure about the passenger side. Quote
The_aSSet Posted November 1, 2012 Author Report Posted November 1, 2012 Found the problem lol I feel dumb, was the coolant block off thing, wasn't bolted down at all Quote
Blown 346 Posted November 1, 2012 Report Posted November 1, 2012 Good, I was going to say if it was the head, the gasket is already crap and you would be doing a a gasket swap. Quote
canadianVRss Posted November 1, 2012 Report Posted November 1, 2012 Found the problem lol I feel dumb, was the coolant block off thing, wasn't bolted down at all Coolent block off thing? Quote
The_aSSet Posted November 2, 2012 Author Report Posted November 2, 2012 The crossover tube that is in the front, there's 2 in the back too but without the crossover tube so it just blocks the coolant from coming out those holes back there Quote
canadianVRss Posted November 2, 2012 Report Posted November 2, 2012 Are those the ones that run through the throttle body? Quote
The_aSSet Posted November 2, 2012 Author Report Posted November 2, 2012 Nah they connect the heads coolant passages its a little metal tube right above the water pump underneath the tb Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.