357ci blower motor/brodix/belt drv/ procharger

[slammedss]

this engine was built using these new parts. the engine was built for a blow through procharger supercharger. the compression ratio is 8.33to1 with the current felpro head gasket. i have invested over $12000 in this motor and have never ran it. with the procharger i had for this it was going to produce around 950hp conservatively on 14psi and 1000+ with 17psi of boost. this motor is a real show piece. the heads have been fully show polished as well as the brodix valve covers. the block and oil pan has been powdercoated. this motor has never been ran and will be available to be taken apart for inspection.

i no longer have the d3 procharger that was on this motor. i was planning on putting a f1r series blower on it do to the size of the compressor of the d3.

i am a procharger distributor and will sell a system at cost with purchase of this motor.

 

PLEASE E-MAIL ME FOR MORE PICTURES AT [email protected] OR LEAVE YOU RETURN E-MAIL ADDRESS IN MY PM BOX.

 

350 4 bolt main block,

.40 over bore/cleaned/prepped,

clearenced for rods,

powdercoated red,

lunati billet crank,

manley 7075 aluminum rods,

venolia flycuy forged pistons,

total seal gapless file fit rings,

arp rod bolts,

arp main studs,

brodix track 1 heads ,

2.08/1.625 valves,

titainium retainers .700 lift springs,

straight plug polished completely,

lunati 1.5 aluminum rockers,

herbert roller cam,

herbert roller lifters,

herbert stud girdle,

manley pushrods,

arp head bolts,

edelbrock victor race intake,

barry grant glod claw 775 carb,

ati ratler 6" balancer,

comp cams dry belt drive,

csi billet water pump,

brodix tall polished valve covers,

arp intake bolts,

moroso hv/hp oil pump,

moroso pump pick up and screen,

canton racing oil pan,

msd pro billet distributor,

hays flywheel,

clevite brgs.

 

please call 812-760-0305 for more info

$5500 obo or will trade for ?