Jonmalibuss Posted December 8, 2004 Report Share Posted December 8, 2004 I'm not sure if this is on here or not but it's very useful and will save a use less trip to the dealer when your batter dies in your key fob eTransmitter Programming silverado: Important Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle. There are 3 methods for programming transmitters which are listed below as method 1-3. Up to four transmitters may be programmed to the passenger door module (PDM). Each programmed transmitter is given a position of #1-#4 in the PDM memory. Method 1 - No Tools Required, Program All Transmitters Important All transmitters which are to be recognized by the PDM must be programmed in a single programming sequence. When using this program method, all previously programmed transmitters will be erased upon the receipt of the programming signal from the first transmitter. The order in which the transmitters are programmed will determine its numbering position within the PDM memory. The first transmitter programmed will be transmitter #1, and the second transmitter programmed will be transmitter #2. The number stamped on the transmitter case is for reference only: #2 can be programmed as #1, or vice versa. Additional unnumbered transmitters are also available. Close all the vehicle doors. Insert the ignition key into the ignition lock cylinder. Press and hold the door unlock switch. While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF. Release the door unlock switch. The doors will lock and unlock to confirm the program mode. Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter. Repeat the previous step to program up to four transmitters. Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter programming mode. Operate the transmitter functions in order to verify correct system operation. Link to comment Share on other sites More sharing options...
edessa Posted December 8, 2004 Report Share Posted December 8, 2004 Link to comment Share on other sites More sharing options...
Xero Posted December 8, 2004 Report Share Posted December 8, 2004 i dont get it, what does it do?! is it if you need a new keyless pad thing? Link to comment Share on other sites More sharing options...
cokedrvrbjw Posted December 8, 2004 Report Share Posted December 8, 2004 its what you do when your battery dies in the remotes for the truck. Thats how to reset them after putting in a new battery. Link to comment Share on other sites More sharing options...
Xero Posted December 8, 2004 Report Share Posted December 8, 2004 oooooooooooooooooooooooooooooooooh i get it by the way whos the hottie? Link to comment Share on other sites More sharing options...
cokedrvrbjw Posted December 8, 2004 Report Share Posted December 8, 2004 The wife to be!! jessica simpson. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.