03_SS_22

it looks clean! still havent been able to see it after he put on the procharger.

that clip is with LTs, ORY, stock muffler, then corsa tip?

here are some pics with it before the tire.

I just bought a used corsa tip and I searched but coundn't find a thread that had what I wanted. Does anyone have a corsa tip exiting before the rear tire? pics? Or do you think I should just exit it out after the rear tire?

the stock l92 heads have a 72cc chamber right?

how much would you mill them? i know the 243 ls6 heads are 64cc chambers that will make my motor 11:1 right? how about with .040 cometic gaskets for a little bit better quench and more compression.

i was thinkin about getting the l92 heads but i would have to mill them to get my compression up right?

Which one would yall go with? I'm gonna go with a built tranny, tranny cooler, 3600+ stall, custom grind cam, ls6 heads, lifters, intake mani., tb, low temp t-stat then a 125-150 wet shot later I forgot LS6 intake.

I got it off the GM high tech performance that I was reading.

http://www.erlperformance.com/index.php?op...p;Itemid=100016

triple dics or single? do you still have the free restall or do we have to pay? sorry for all the questions

what was it built for? your truck on TT?

very nice.

go to your local exhaust shop would prolly be cheapest but these are decently priced. http://www.jegs.com/p/JEGS/JEGS-Exhaust-Tu...752880/10002/-1

what is the inlet size of the corsa tips? isnt there a clone tip that someone makes?

so does the TVS like the same stall as the MP series? 2600-2800?

never put 87!!!! 91 or better!!!!!!!!

steeting shaft is easier.. just mark it so you put it in the same position it was. then it put it back together

thats with the catted setup? its 3" duals right?

Sometimes on a cold start when I take off it stays in 1st. I have to let go of the gas to or give it more gas. it doesnt just shift smoothly. Is my tranny going out??? Eric

ARH are top notch quality i thing the GP ended at the end of june.

what size primaries are they?

what materials are yall using?

the 243s may boost your compression to high. 317s should do well.

where are you located? can i get a pics of the cam and cam card?