Stanley
Member-
Posts
65 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Store
Everything posted by Stanley
-
I'll post some pictures this weekend.
-
Sacramento California
-
I'm thinking about selling my 2005 Silverado SS due to some health issues. It's black with a 2" lowering kit and a Volant filter and scoop other than that it is bone stock. I has about 80,000 miles on it but since I,m old school I have all of the dealer maintenance records. What would be a good price to sale it for?
-
I have the same problem when I make a sharp left turn going forward or a sharp right turn in reverse. The problem can be greatly reduced by using a few large zip ties to keep the inner fender from the front right tire.
-
4l80e Nvg-149 32 Spline Input Gear Adapter
Stanley replied to Time2Kill's topic in AWD, Differential, & Transmission Tech
How much horse power can the NVG-149 Transfer case handle? -
Has anyone installed a SLR Motorsports tune? They advertise 50HP and 50ft/lb of torque for $70.00 It just sounds too good to be true
-
I'm in Sactown & I'm down
-
That angle does look extreme; after I dropped my rear 2-inches I have a slight vibration from 68 to 75 mph. According to the forum at the beginning of the suspension section you need about a degree of correction for every inch dropped but, I could not find anyone to tell me what the range of allowable pinion angles are required for a smooth ride. That would indicate which shim is correct before you finished the correction. The nest time I’m at the dealer I’ll try and find out what is an acceptable range for the pinion angle. With that being said you angle looks extreme, maybe you do have the shims in backwards.
-
I’ve looked at several exhaust systems including the Corsa and none of the metal used on any of them appear to hold up as well as the metal on my three year old stock SS exhaust. Also the bends on most of the aftermarket exhaust appear more severe than on the stock exhaust. Therefore I can’t see where all of the horsepower gains come from. The only weakness I see on the exhaust is the piping between the exhaust manifolds and the muffler flange which is not changed in cat back system. I think that a replacement in that part of the system would yield more horsepower gains than a cat back system over the exhaust system used on the SS. I do agree that replacing the muffler might yield some gains if the connections between the muffler and adjoining pipes were done correctly.
-
Collection of Lowering Notes and Best Practices
Stanley replied to misterp's topic in Suspension & Brakes
Can you tell me what the pinion angle is on a stock All Wheel Drive 05 SS? -
I bought a set from American Tire abut a month ago. I replaced the original tires with almost 56,000 miles on them. The X's are very quite at this point, ride much smoother and may handle a little better. The one small down side that the side walls may be a little stiffer therefore the ride is a little harsher.
-
I installed spindels and hangers then replaced the hangers for shackles. Both gave me a 2-inch drop in the rear which leaves the front about 2-inches lower than teh front. A 2/4 drop sounds about right to me, I'd go with the leafs if I did it again.
-
I'll switch to a rear schakle and see if the vibration goes away. I guess my vibration is closer to 70 to 75 mph. If iI could find out what the acceptable range of angles were I could shim the pinion accordingly.
-
I was under the impression that the hangers would give me a 2 inch drop, I thought that the shakles woud drop the rear too low.
-
I used Beltech spindles up front and spring hangers in the rear which gave me a 2 inch drop in the front and a 1 1/2 inch drop in the rear. Also, I never noticed before the drop but the front differential now is lower than the center of the front wheels.
-
Since lowering my 05 SS I get slight vibration above 75 mph. What range of angles should the front and rear axles on an AWD SS be after lowering to eliminate vibrations. I’m in the opinion that the angle of the front axle is too steep.
-
I used a little HVAC foam that I bought from Home Depot for less than five dollars.
-
Will 305/50R/20 tires? Fit on stock SS wheels? Also will that combination of 305/50R/20 tires and stock wheels fit and 05 SS with a 2” drop front and rear?
-
Any One Got A Single 20" Tire They Want To Sell New Or Used
Stanley replied to peteleonardo's topic in For Sale/ Wanted
I have an 2005 SS and my spare has never been used I'll sell it for $100, I live inNorthern California -
Need help picking an aftermarket grille
Stanley replied to 00silverad0's topic in Appearance, Cleaning, & Detailing
Race Mesh has finally started making a grille for SS, you should check out their web site. -
Racemesh Grill for Silverado SS
Stanley replied to yorgog's topic in Appearance, Cleaning, & Detailing
-
That kit will go oanan AWD truck!
-
Who has a AWD with Belltech Lowering Leafs???
Stanley replied to REDSS2NV's topic in Suspension & Brakes
How much of a drop did you get from them?