Thing1 Posted September 15, 2012 Report Share Posted September 15, 2012 I installed some switchback bulbs from DDM into my silverado. I was able to fix the flashing with the turn signal by installing Load Resisters (25 OHM 25W) but my taillights still are flashing... I have aftermarket LED Taillights so this may be more difficult than on a factory one but I figured out that the dark blue wire is the one that needs a resister. I tried using this but still doesn't work. The resister is spliced because I wanted to test it with a wire tester and it still makes the wire tester flash so that didn't fix the problem.. Any ideas? Quote Link to comment Share on other sites More sharing options...
jeremybieser Posted September 15, 2012 Report Share Posted September 15, 2012 use these resistors, one per side for the turn signals 50w 6 Ohm , mine no longer hyperflash and i have led everything minus hid high/low/fog. Quote Link to comment Share on other sites More sharing options...
Thing1 Posted September 16, 2012 Author Report Share Posted September 16, 2012 (edited) Nevermind, the stupid resistors DDM sent were broken and I had to go down to the parts store and buy more. -.- Thanks for the input! Edited September 16, 2012 by Thing1 (see edit history) Quote Link to comment Share on other sites More sharing options...
RebelOne Posted September 26, 2012 Report Share Posted September 26, 2012 GM's need 3 ohm resistors. Mine work great with them Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.