moog5050

Tanks from TrickPerformance. Rick did a great job and has great customer service.

TTT - make me an offer

Clean all the grounds and make sure the new grounds for the nos solenoids are solid. I had ground issues and they can be difficult to identify.

You may need a thin wall socket for the lugs depending on your wheel

Congrats Brad

Up again for an offer or trade

Be careful if you go with the Porter Cable. Keep it at lower speeds b/c even though it is a random orbital, it will burn the pain. I know. It is a nice machine however.

otra vez

for the day

Thanks Brad. Very Helpful

Thanks Brad. Can't see the picture at work but will check later. How much timing are you running at WOT? I have a 2.9 and was told by the tuner that I am not near maxing out (not sure of the percent). MY AFR is in the 11.5 range WOT. I was thinking about dropping to a 2.8 with the new pulley, but don't relish the idea of swapping injectors. I know the timing on mine is low and I am leaving a lot on the table still (only 15.5 WOT), but Turboberzerker agreed to help me retune (and teach me) this spring. Trying to get to Krambo's recommended 20 at WOT, but the shot of N2O I am installing may change that a bit. The N2O has a stand alone fuel system so that shouldn't impact injectors.

Truthfully I am very impatient. I might just try the 8 rib and see how it goes or maybe I'll just buy the 6 rib. I guess I am decidedly undecided. Brad did you upgrade from the 42s to use the 2.8?

I am currently running a 2.9 on my radix. I would like to upgrade to something with more bling. I can get a new 8 rib Reichard for cheaper or a 6 rib directly from Reichard for more. Do you think that I will have a problem with the belt moving off track using an 8 rib. I may upgrade to an entire 8 rib set up at some point, but not yet.

Make me an offer

You will likely do it anyways. I went from 3.4 to 3.0 to 2.9. It really isnt bad, you just need a good tuner. Luckily, I haven't had the slippage problems like Brad.

TTT

Purchased from a member on PT.net and never installed. Decided I don't need it. Was told it has everything needed for the install and from my check it looks good. Paid $215 shipped and looking for the same. PM me. Thanks.

Nice job Ben

For those interested, I have purchased two items from Ryan. He is a good seller.

Ben Not sure about the NOS bottles, but the blow off valve for Nitrous Outlet bottles screws into the stem of the bottle. Check with Nitrous Outlet. They should know if the NOS bottle has the same pressure relief valve. Brian

there is a sticky in the nitrous section of PT.net

No problems encountered with my ported TB, before or after the radix install.

-deleted by poster-

TR6 is recommended for both apps.

Hotrod, thanks for the link. Not sure why I couldn't find that, but it was a big help. Lilmarv, I just did a search in this section for wind noise. His thread is not a complete how to, but includes a couple of photos.