d.nadeau69 Posted June 20, 2008 Author Report Share Posted June 20, 2008 Quote Link to comment Share on other sites More sharing options...
NTMD8R_SS Posted June 21, 2008 Report Share Posted June 21, 2008 Thanks for the pics, what did you do to the 2* shims? i may need some from when i drop mine some more. Quote Link to comment Share on other sites More sharing options...
blackvert Posted June 30, 2008 Report Share Posted June 30, 2008 is that a 2/4 pictured? Quote Link to comment Share on other sites More sharing options...
NTMD8R_SS Posted June 30, 2008 Report Share Posted June 30, 2008 yes. Quote Link to comment Share on other sites More sharing options...
JSTAL Posted July 2, 2008 Report Share Posted July 2, 2008 i had the 2" shackle drop in the rear with the 2 degree axel shims to correct pinion angle. along with the 2" drop spindles. i had a slight vibration @ about 70-75. so i decided to put the mcgoofys 2" hangers in and get rid of the axel shims. i also turned down the torsion bars 3 complete turns to set the truck dead leve front and rear. also installed 4 new belltech nitro active drop 2 shocks. now i have a serious vibration @ 70-80, felt in the seat floors and wheel. i know people have done the same mods and have had no trouble, what are people doing that have had vibration issues? one thing i noticed was that with this 4" drop in the rear the slip yoke is stuffed into the transfer case. is a shorter drive shaft needed? or is this ok.??? i have a 2/4 beltech drop my drop cam with shims and a carrier bearing kit. You must relocate the carrier bearing on the beltech or you will get driveline vibration du to the angle the u joints are at. I did not read the whole thread but the carrier bearing relocation kit will solve the issue Quote Link to comment Share on other sites More sharing options...
blackvert Posted July 2, 2008 Report Share Posted July 2, 2008 would it be possible to start a sticky thread of drops/pics for reference? Quote Link to comment Share on other sites More sharing options...
Tony-CA Posted July 12, 2008 Report Share Posted July 12, 2008 i have a 2/4 beltech drop my drop cam with shims and a carrier bearing kit. You must relocate the carrier bearing on the beltech or you will get driveline vibration du to the angle the u joints are at. I did not read the whole thread but the carrier bearing relocation kit will solve the issue AWD SS trucks dont have driveshaft carrier bearings. Its just a one piece driveshaft straight to the transfer case. Quote Link to comment Share on other sites More sharing options...
JSTAL Posted July 12, 2008 Report Share Posted July 12, 2008 AWD SS trucks dont have driveshaft carrier bearings. Its just a one piece driveshaft straight to the transfer case. ah yes thats right im retarded Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.