garagemethods Posted January 16, 2009 Report Share Posted January 16, 2009 so i got my pillar pod. its got a outside air temp, tach, and speedometer. does anyone have a good write up for this installation or could tell me how to do it? Quote Link to comment Share on other sites More sharing options...
DGIEPSS Posted January 17, 2009 Report Share Posted January 17, 2009 i just used two way tape to hold mine to my piller Quote Link to comment Share on other sites More sharing options...
garagemethods Posted January 17, 2009 Author Report Share Posted January 17, 2009 i'm gonna screw it in with the screws it came with. but i was asking about wiring the gauges. i need to know where that part on the tranny is for the speedometer, and where to wire in on the engine for the tach. Quote Link to comment Share on other sites More sharing options...
Jaymz Posted January 17, 2009 Report Share Posted January 17, 2009 (edited) i'm gonna screw it in with the screws it came with. but i was asking about wiring the gauges. i need to know where that part on the tranny is for the speedometer, and where to wire in on the engine for the tach. I'm just guessing by looking at your picture there, your VSS should be located on/near your tailhousing You should be able to tap into your existing wiring for a tach, if the pickup didnt not have one, locate your coil, and follow the directions for the manufactorer of the gauge Edited January 17, 2009 by D.J (see edit history) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.