j4nash Posted January 18, 2005 Report Share Posted January 18, 2005 i got the 5 line kit from Earls and now both front lines have gone bad Link to comment Share on other sites More sharing options...
slimsoftball Posted January 18, 2005 Report Share Posted January 18, 2005 Did you make sure that put the straight surface toward the caliper and not the angled one like Ben mentioned when he did his. Not saying you don;t know what your doing. Just trying to rule out the obvious. Link to comment Share on other sites More sharing options...
j4nash Posted January 18, 2005 Report Share Posted January 18, 2005 what do you mean put the straight surface toward the caliper and not the angled one. Link to comment Share on other sites More sharing options...
slimsoftball Posted January 18, 2005 Report Share Posted January 18, 2005 what do you mean put the straight surface toward the caliper and not the angled one. <{POST_SNAPBACK}> Luckily I snapped some pictures after I read what Ben had to say awhile back. Notice how when you look at the block from the side you can tell which side will lay flat. Link to comment Share on other sites More sharing options...
j4nash Posted January 18, 2005 Report Share Posted January 18, 2005 My problem was at the other end of the line at the bottom of the fitting it was leaking Link to comment Share on other sites More sharing options...
slimsoftball Posted January 18, 2005 Report Share Posted January 18, 2005 My problem was at the other end of the line at the bottom of the fitting it was leaking <{POST_SNAPBACK}> Rules that out then I hope you figure it out. Link to comment Share on other sites More sharing options...
j4nash Posted January 18, 2005 Report Share Posted January 18, 2005 i just put the factory lines back on Link to comment Share on other sites More sharing options...
BenKey Posted January 21, 2005 Report Share Posted January 21, 2005 Hey, good snaps, Eric. Just hope all can understand what I have been saying now. The pic where it shows the end flush to the table (in your pic) is the end that goes to the caliper. Got yours on yet? Going to a better fluid also? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.