Jump to content

cb2big4u

Member
 View Profile  See their activity

  • Posts

    1,054

  • Joined

  • Last visited

  • Days Won

    5

 Content Type 

Posts posted by cb2big4u

  1. 4l80e Nvg-149 32 Spline Input Gear Adapter

    in AWD, Differential, & Transmission Tech

    Posted

    I do not understand what bump means, Thanks for letting us know you still modify these input shafts on an as needed basis. I am in need of one.

    I have the Input shaft out, ready to send to you with payment. I sent you a private message with my information.

    Thank you.

    Bump, on a forum, means to bump the post to the top. So that it stays fresh and on the front page or in the new content section.

     

    Sent using Tapatalk.

  3. spark plugs/ new to site

    in Bolt On Performance

    Posted · Edited by TampaVmax (see edit history)

    The tr55ix are a .060 gap. The tr5ix are .040 gap. They are what I run. Technical Service Bulletin had a notice to go to lower gap plugs to prevent misfire or some shit. I followed and works great. Most guys still run the 55 though.

     

    Sent using Tapatalk.

    Applies to what he told you to get also. You will be fine.

     

    Sent using Tapatalk.

  7. head light issue

    in General SS

    Posted · Edited by TampaVmax (see edit history)

    Hmm...if you are worried about a bad ground you can always test resistance between grounds. Put one lead on the battery negative ans one lead on the headlight negative and it should be extremely low if not .1-.5

     

    Sent using Tapatalk.

     

  8. head light issue

    in General SS

    Posted · Edited by TampaVmax (see edit history)

    What's voltage at the battery without starting the truck after it sits for a day or two? If you have it started and headlights on, have someone roll up the window and hold it even when its up and see if it dims even further. Sounds like a battery issue to me.

     

    Sent using Tapatalk.

     

  12. which amp for 2 jl audio 13.5s

    in Radio/Electronics/Security

    Posted · Edited by TampaVmax (see edit history)

    Most amps will provide higher output if you lower the load. So two 4 ohm dual voice coil speakers in parallel provide a 1 ohm load to the amp. An amp that would push 1000 watts at 1 ohm would usually be around 250 watts at 4 ohm. JL on the other hand has done a great job at making most of their better amps give the wattage rating across all loads. So your 1000/1 would give 1000 watts at 4ohm as it would at 1ohm.

     

    Just putting that out there. To answer your question, the wattage would be divided by however many speakers you would hook to that amp.

     

    Just a heads up, for the price of 2 1000/1 or that 2500bd you could get an amp that would push more power for less money. Do you have any supporting electrical for all this power?

     

    Sent using Tapatalk.

     

  13. Magnaflow long tubes

    in Bolt On Performance

    Posted

    Tsp is stainless which is legit.Sent using Tapatalk. there's two different kinds of stainless 4xx something and 304. One will still rust pretty quick. Anything 304 will cost you a lot of coin but will last years. Just wanted to throw that out there.

     

    Word. Never seen the 4** but the Texas speed are 304. Won't they change cool colors with heat also?

     

    Sent using Tapatalk.

     

     

  14. which amp for 2 jl audio 13.5s

    in Radio/Electronics/Security

    Posted

    Since the jl amps are not strapable. I woud go with the Rockford. If you ran 2 1000/1 and had each sub in its own enclosure with its own port then by all means it doesn't matter which one you choose. You can also have the 2 1000/1 and just gain match them with one of smd's creations and just use a dual sub box like you would the Rockford. A lot more amp choices out there also. Hope you have the electrical to push the stuff.

     

    Sent using Tapatalk.

     

     

  19. Bye Bye Lightning.

    in Street

    Posted · Edited by TampaVmax (see edit history)

    I had the same story a while back. Had a lightning on the interstate and every time we would go I would pull on him. Ever so slightly but enough to just keep pulling away. I caught the same flak when I posted about it. On the books there is no way it would seem. I had the same experience though. Maybe we are playing with some broke ass lightnings.

     

    Sent using Tapatalk.

     

  20. Home alarm system Vivint vs ADT

    in Off-Topic/General

    Posted · Edited by TampaVmax (see edit history)

    I install home security. I despise ADT. They rape you with 35-40$ a month and a contract that god help you try to back out of. It's not always wise to go with a big company. You get a slap chop job and as stated above get wrapped into a contract.

     

    I charge flag out for my systems to install but its yours to keep and then I charge 19.95$ a month. Local monitoring center with great response time and all. Obviously I couldnt be able to do it but just stating, peek around a little. Only wish I could refer someone :( All the equipment for the most part is made by the same companies. Honeywell/ademco, hai, elk, ect... It's just rebranded to say ADT or whoever.

     

    Sent using Tapatalk.

     

  25. Finally ordered my wheels

    in Rims and Rubber

    Posted

    That's awesome! They are great wheels. Pain to keep the water spots off of... I want to know how those nexens ride. I was very sketchy about them but they are like the only decent priced tire in that size. I ended up getting a retarded deal on my falkens for 900$ all 4 new.

     

    Sent using Tapatalk.

     

     

×
×
  • Create New...