Jump to content

80E is in


Recommended Posts

  • Replies 51
  • Created
  • Last Reply

Well i'm back from the track.

Leaving on higher boost was better but caused some tire spin that is hurting my times a little. The trans shifted awsome and the lowerfirst gear ratio does not seem to hurt me.

Best run was my first. Launched at 10psi with a quick ramp up to about 15psi.

 

60 1.7182

330 4.9400

1/8 7.6652

1/8mph 89.64

1000ft 10.0470

1/4 et 12.0782

1/4 mph 110.84

 

 

Kurt

Link to comment
Share on other sites

  • 2 weeks later...

4L80E installed in the syty setup using a JSM conversion kit. Still working out the details with the ecm:

abz.jpg

Lots of guys will probably be going this route in the future. Not as expensive as you might think. Just depends on what your personal capabilities are.

Link to comment
Share on other sites

  • 2 weeks later...

Made it to Florida on the long haul Power tour.

Ran the quarter in Indy on the third leg. ET's were 11.75-11.81-11.79 all at 115.XX

Trans seems to work well, still have the torque management on.

 

 

Kurt

Link to comment
Share on other sites

Made it to Florida on the long haul Power tour.

Ran the quarter in Indy on the third leg. ET's were 11.75-11.81-11.79 all at 115.XX

Trans seems to work well, still have the torque management on.

 

 

Kurt

Very nice truck man and it was good to meet you in burmingham AL, I just happened to be looking for a bar to have a few drinks at BTW never go out and walk around that place at night!!! Very nice times BTW! :thumbs::thumbs::thumbs:

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.


×
×
  • Create New...